AMF Failure – automatic mains failure panel (AMF) failure can happen
Automatic mains failure panel (AMF) is a device that automatically transfers the electrical power supply from its primary source supply to a backup source, ‘standby power generator’, when the AMF senses a failure or outage in the primary supply source,( which is usually the national GRID supply).
An Automatic mains failure panel (AMF) consists of copper bars and contactors, which keep the primary power source separated from the standby power source in an isolated manner.
The Automatic mains failure panel (AMF) constantly monitors the supply for harmonic distortion, which it ‘sees’ as being a prelude to a power loss.
Should the Automatic mains failure panel (AMF) ‘see’ the primary power source operating outside of safe operational parameters then the AMF will automatically isolate the primary power source and switch over to the backup power source as well as sending a start signal to the backup generator to start up and provide power.
This action will happen, without human intervention, either prior to the power loss event of within seconds of sensing the power loss.
1.The Electrical power to your building is usually supplied from the primary power source, which is the National GRID supply.
2.The AMF is constantly monitoring the quality of the primary power source since it was installed by Power Continuity Systems.
3.When a failure occurs in a primary power system, the AMF will automatically isolate the primary power source and switch over to the backup power source, within seconds.
4.The AMF sends a start signal to the backup generator
5.Your backup generator starts to take the building load with 20-30 seconds, completely independent of the failed GRID supply.
If you can hear ‘chattering’ this is a sign that debris is bouncing around between the contactors in your AMF. Your AMF will still operate BUT….. it is an indication that parts are wearing and in need of replacement during the coming 12 months.
If you can smell ‘burning’ emanating from the AMF then this is a sign that the terminals or some of the terminals have burned out. REPLACE immediately as your ATS won’t operate without replacement.
Loose Metal debris inside the AMF will cause a ‘Buzzing’ sound.
Get your local generator engineer to isolate the AMF and clean out all metal debris . Clean and then safely re-energise the Automatic mains failure panel (AMF)
4.CONTROL PANEL DEAD
Without a visual operating control panel your AMF will NOT operate.
If the control panel has NO life and NO images then as a matter of urgency replace with a NEW control panel.
Control panels can fail due to age or component failure
The cookie settings on this website are set to "allow cookies" to give you the best browsing experience possible. If you continue to use this website without changing your cookie settings or you click "Accept" below then you are consenting to this.